WBUT Question Papers EC Analog Electronic Circuits B Tech Forth Sem 2010

WBUT Question Papers EC

Analog Electronic Circuits B Tech Forth Sem  2010

Time Allotted. ‘. 3 Hours

the figures in the margin Indicate Jiillmarks.

Candidates are required to give their answers in their own words

as far as practicable.

GROUP-A (Multiple Choice Type Questions)

  1. Choose the correct alternatives for any ten of the following :    10 x 1 = 10
  2. i)     To start the oscillation, the gain of a Wien-bridge

oscillator is to be

a)            > 1

c)             < 1

 

ii)            The o/p imp. of a series voltage amplifier is

 

a)             K0/(l+pA)

c)              pR0/(l+A)

 

iii)          Max. phase shift in a two-pole network is

b)    150°

d) ?70°.

 

 

iv)          Power amplifier handles signal which is compared to voltage amplifier,

a) small                                                  b) very small

c) large                                                 d) none of these.

v)            Schmitt trigger is also known as

a) squaring circuit                           b) blocking oscillator

c) sweep circuit                             d) astable multivibrator.

vi)          For a wide range of oscillations in the audio range, the preferred oscillator is

a) Hartley                                   b) Phase shift

c) Wien-bridge                            d) Hartley and Colpitt.

vii)        Astable multivibrator may be used as

a)            frequency to voltage converter

b)            voltage to frequency converter

c)             squaring circuit

d)             comparator circuit.

viii)      An instrumentation amplifier

a)             is a differential amplifier i

b)             has a gain less than 1

c)             has very high output impedance

d)            has low CMRR.

ix)          The © point In a voltage amplifier is selected in the middle of the active region because

a)             it gives better stability

b)             the circuit needs a small d.c. voltage

c)             the biasing circuit then needs less number of resistors

d)             it gives a distortionless output.

x)             An ideal regulated power supply should have regulation which is

a)             maximum                         b) 50%

c) zero                                         d) 75%.

xi)           To avoid false triggering of the NE 555 timer, the RESET pin ( Pin 4 ) is generally connected to

a)             Pin 8                                b) Pin 1

c)              Pin 3                                 d) No connection ( NC ).

xii)         In a logarithmic amplifier, the logarithmic effect of the input is obtained from ,

a) non-linear device, like diode or transistor

  b)       negative feefd-back

c)             the Op-Amp itself

d)             the inverting input terminal.

xiii)   The value of V0 for the following circuit is given by

xiv)       Differential amplifier can be used to amplify

a)            only A.C. signal (input)

b)            only D.C. signal (input)

c)             both A.C and D.C. signals

d)            none of these.

xv)         Heat sinks are used in power amplifier circuits primarily to Increase

a)            the output power

b)            the voltage gain

c)  Collector dissipation rating of the transistor

d)            dissipation of energy of free electrons.

 

GROUP-B (Short Answer Type Question

Answer any three of the following. 3×5=15

  1. What do you mean by clamping circuit ? Draw its circuit diagram and discuss its operation.
  2. • What is Common Mode Rejection Ratio ( CMRR ) and Slew

rate of Operational Amplifier ?

  1. What is the difference between series and shunt regulators ? Draw the circuit diagram of a series regulator.
  2. List the three sources of instability of collector current in a transistor. Define three stability factors.

GROUP-C (Long Answer Type Questions)

Answer any three of the following, 3 x 15 * 45

  1. a) Draw the circuit diagram of an emitter follower and

explain the nature of feedback in this circuit. What is the feedback topology of the emitter follower ? Derive an expression for the voltage gain of the /Circuit from the concept of feedback.            2+1+3

b)             Show that negative feedback improves the stability of the gain of an amplifier.            4

c)            The open-loop gain of an amplifier is – 200. A voltage

series negative feedback is used with a feedback ratio of

The Input and the output impedances of the amplifier are 2 kQ and 40 kQ, respectively in the absence of feedback. Determine the closed loop gain, and the input and the output impedances when the feedback circuit is completed.                                                                                5

  1. a) Draw & explain a circuit which uses a diode to compensate for changes

b)            Quiescent levels of the network in figure are given as : Ic»-MmA&VC£e-3’7V. When 10V,RB= 250k

& transistor parameters are p = 90 & VBE -0-7 V and at room temperature, find RC&RE.

  1. a) Drw the circuit diagram of a voltage to current

converter ( grounded load ) and explain its operation. 5

b)  What is Schmitt trigger ? Explain with circuit diagram. *

c)    Explain Logarithmic amplifier with circuit diagram. 5

  1. a) Draw the a.c. equivalent circuit of dual input balanced

output differential amplifier and find out the expression of differential gain ( Aid ), input impedance, output impedance.                                                                  10

b)            Mention the advantages of active filters over passive filters.   5

  1. Write short notes on any three of the following : 3×5=15

 

a)            Comparator

b)            Astable multivibrator

c)             Schottky diode

d)            Switch Mode Power Supply ( SMPS )

. e)          DC load line.

Leave a Comment