GTU Applied Electronics Question Paper June 2011

GTU Applied Electronics Question Paper June 2011

  

             GUJARAT TECHNOLOGICAL UNIVERSITY

B. E. Sem. – V – Examination – June- 2011

Subject code: 151006

Subject Name: Applied Electronics

     

Total Marks: 70

Instructions:

  1. Attempt all questions.
  2. Make suitable assumptions wherever necessary.
  3. Figures to the right indicate full marks.

Q.1 (a) Draw the block diagram of a regulated d.c. power supply and explain 07 briefly the function of each block.

                    (b) Draw the block diagram of an OP-AMP and explain the function of each 07 block.

Q.2 (a) Explain the operation of an astable multivibrator using IC 555. Draw its 07 circuit diagram and waveforms.

(b) Define the following parameters.                                                                                  07

1)      Common Mode Rejection Ration ( CMRR )

2)      Latching current ( IL ) of an SCR.

3)      Trace period and retrace period of C.R.T.

OR

              (b) With the help of the block diagram, explain the operation of a single trace  Cathod Ray            Oscilloscope. ( CRO )

Q.3 (a) Derive the expression of OP-AMP for non-inverting closed loop voltage  gain. ( Avf )

                   (b) Explain the construction and operating principle of a semiconductor strain  gauge. State its   

                        advantages and applications.

OR

Q.3 (a) Define intrinsic stand off ratio ( n ) of UJT and explain its use as relaxation  oscillator. Dra

            the relevant waveforms.

                    (b)  Explain construction and principle of operation of photoconductive cell.

 

Q.4 (a) Explain in detail the half adder and full adder circuit using logic diagram. Design a monostable 555 timer circuit to produce an output pulse 165 msec 04 wide. Draw the circuit diagram. Determine the value of external component Ra if C=1 F

       (b) Compare RTD and Thermocouple.                                                                    

OR

(b) Draw the block diagram of 8051 microcontroller. Explain each block briefly.

Differentiate between microprocessor and microcontroller.                                              

Explain Read Only Memory ( ROM )

 

Q.5  Write a short note. ( ANY TWO )

          (a) Linear Variable differential Transformer ( LVDT )

           (b) Phase measurement with the help of the Lissajous figures.

            (c) Successive Approximation Analog -To- Digital conversion.

          (a) 1) I-Pod 2) RFID.

                                                                                                                                                                           

Leave a Comment