Sample question papers Mumbai University IT 4th Sem Principles of Communication Engineering

Sample question papers Mumbai University

IT 4th Sem Principles of Communication Engineering

N. B. : (1) Question NO.1 is compulsory.
(2) Attempt any four from remaining questions.
(3) Assume suitable additional data if necessary and state them clearly.
1. Answer the following ;-

(a) What is meant by signal to noise ratio? Discuss the importance of SNR in radio receivers. 4
(b) What is companding? 4
(c) Explain how image frequency signals are received in a super hetrodye receiver. How 4
can these signals be rejected?
(d) Describe the ground wave propagation. 4
(e) What is peak clipping and diagonal clipping in diode detectors? 4
2. (a) A carrier wave Vc = 4 sin [ 21t x 500 x 103 t] is amplitude modulated by an audio wave 10
\ Vm= 0.2 sin [C27tx500 t)] + 0.1 sin 5 [ (2 7tx 500t)]. .
Determine the upper and lower sidebands and sketch spectrum of the modulated wave. Find
the total power in the sidebands.
(b) Explain the following ;-
(i) Balance slope detector
(ii) Delta Modulation.
3. (a) What are different methods for FM generation? Sketch the circuit and explain the principle of 10
reactance modulator? Why is direct modulation not preferred for generation?
. (b) In an FM system, the audio frequency is 1KHz.and audio voltage is 2 volts. The deviation is 10
4 KHz. If the AF voltage is now increased to 8 volts and its frequency dropped to 500. Hz, find
the modulation index in each case and approximate band width of the signal.
4. (a) What is multiplexing in communication system? Draw the block diagram of TDM-PCM system. 1.0
Explain each block. Also calculate the bit rate at the output of this system.
(b) State and prove the sampling theorem for lowpass band limited signal. Compare PAM and PWM. 10
5. (a) Draw the block diagram of phase .cancellation SSB generator and explain how the carrier and 10
. unwanted sidebands are supressed. What changes is necessary to supress the other sideband?
(b) In an AM receiver having no RF stage, the loaded Q of the aerial coupling circuit is 125. If the 10
intermediate frequency is 465 KHz,
find: (i) The image frequency and its rejection at 1 MHz and 30MHz.
(ii) The IF required to make ttie image rejection ratio as good at 30 MHz as it is an MHz.
6. (a) (i) Draw the circuit diagram of a Foster-Seeley phase discriminator and explain its principle 6
of operation with the help of relevant waveforms.
(ii) A continuous time signal X(t) = 5 sin 2000 7t t+ 7sin 40007tt is to be sampled. Calculate 4
the minimum. sampling frequency.
(b) How is adaptive delta modulation better than linear delta modulation? Draw block diagram of 10
adaptive delta modulation and explain each block in detail.
7. (a) Describe the following terms in relation with sky wave propagation.
(i) Virtual Height
(ii) Critical Frequency
(Hi) Maximum usable frequency
(iv) Skip distance.
(b) Write shoft notes on the following (any two) :-
(i) Vestigial side band transmission (VSB)
(ii) FM noise triangle
(iii) High level AM transmitter.

Leave a Comment