GTU Microprocessor and Interfacing Syllabus

GTU Microprocessor and Interfacing Syllabus

 GUJARAT TECHNOLOGICAL UNIVERSITY
B.E Semester: 4
Computer Engineering
Subject Code 140701
Subject Name MICROPROCESSOR AND INTERFACING
Sr.No Course content
1. Introduction to Microprocessor, Microprocessor systems with bus
organization, Microprocessor Architecture & Operations, Memory, I/O
Device, Memory and I/O Operations
2. 8085 Microprocessor Architecture, Address, Data And Control Buses, Pin
Functions, Demultiplexing Of Buses, Generation Of Control Signals,
Instruction Cycle, Machine Cycles, T-States, Memory Interfacing.
3. Assembly Language Programming Basics, Classification of Instructions,
Addressing Modes, 8085 Instruction Set, Instruction And Data Formats,
Writing, Assembling & Executing A Program, Debugging The Programs,
Decision Making, Looping, Stack & Subroutines, Developing Counters And
Time Delay Routines, Code Conversion, BCD Arithmetic And 16-Bit Data
Operations.
4. Interfacing Concepts, Ports, Interfacing Of I/O Devices, Interrupts In 8085,
Interfacing of Data Converters (D-To-A And A-To-D), Programmable
Interfacing Devices Like 8279 Keyboard/Display Interface, 8255A PPI,
8253/8254 Timer, 8259A PIT, 8237 DMA Controller, Serial I/O Concepts,
SID And SOD, 8251A USART. Interfacing of above chips With 8085,
Programming them In Deferent Modes, Practical Applications
Reference Books:
1. Microprocessor Architecture, Programming, and Applications with the 8085 –
Ramesh S. Gaonkar Pub: Penram International.
2. Microcomputers and Microprocessors: The 8080,8085 and Z-80 Programming,
Interfacing and Troubleshooting by John E. Uffenbeck.
3. Microprocessor and Microcontroller fundamentals. The 8085 and 8051 Hardware and
Software by William Kleitz.

Leave a Comment